How To Tune Your Bow? Tuning Or Adjusting Your Bow Helps You To Boost Your Chance Of Hitting Target.
A bow must be tuned so that the shooter gets consistent arrow flight and you improve the accuracy of your shots. Tuning is described as adjusting your bow so that you boost your chance of hitting the target. Tuning at present is simpler since all bows are center shot and there are already carbon arrows that fall within a wide range of draw lengths and bow weights. Years before, arrows need to be bended around the riser to clear the bow.
The arrow has to be spined off adequately for the bow and so that the fletching does not hit any other part of it. You should adjust the nocking point and rest so that the arrow will be pointing straight toward the target during release. To adjust the center shot, you have to understand that the string is not consistently in the center of the bow limbs. Some devices that set the center shot may not function properly since there are assumptions that all things are square when they actually are not. The bow string has to travel in a line parallel to the sight window on well-made bows.
Keeping It Parallel
The arrow on the rest should be parallel to the sigh window. The arrow should be placed on the rest and look down on it. Move the rest until the arrow becomes parallel to the sight window. A block can be used to draw a line on the shelf parallel with the sight window and then line the arrow up using the line. Look at the bow with the arrow on the rest and line the string up with the arrow center. The string must be close to the grooves of the cam. This will be an ideal starting point. The spine of the arrow and your proper form are other determining factors.
The Nocking Point
The arrow must be level according to some archers. Others also say that the nock has to be a little high. The rest, bow and arrow and your shooting will determine the most ideal way to set the nocking point. You can usually get good clearance from the rest if the nocking point is a bit high. The arrow, in response, will rise above the rest when you shoot instead of slamming down into the rest. A lot of individuals current shoot a kind of prong type rest.
It will be difficult to ascertain where the nocking point must be located since majority of bow squares have a unique size compared to the arrow so the set will be different in the rest and will be either lower or higher compared to the arrow. An ideal starting point is to view the arrow on the rest. The nock must be slightly high making the arrow angle down. The angle will appear bigger on short brace height bows since the string is near the rest. Use the square to record where the nocking point is found on the string. This is your starting point.
Doing a Powder Test
The powder test will determine if the fletch or arrow hits the rest. Spray the fletch area of the arrow with some foot powder. Shoot the bow in your perfect form. Observe the fletch of the arrow and observe if the arrow made contact with the rest. A slight drag mark in the powder can appear between the fletch where the arrow went through the rest. Move the rest right or left until the fletch moves between the prongs without making contact. Adjust the nocking point down or up if you see any drag mark. Mark the rest with a pencil and mark the nock location on the square.
Shooting is the next test. The arrow rest can be adjusted by as much as 3/8 of an inch on a forgiving bow, and still provide you good arrow flight. Within the 3/8 inch, you can find areas that are ideal for shooting. The same theory applies for the nocking point. A shooting test can help you locate the best position for the nocking point and the rest. Make one adjustment every time, beginning with the arrow test.
Sight the bow well then make a cross on the target. Get back as far as possible, allowing you to shoot decently. Shoot a 5 arrow group with your best form. Do not change the sights if you are not hitting the center of the cross. Shoot for one group. Record the horizontal size of the group. Record the horizontal group size and determine where the groups are tightest for left or right. Do the same for up and down on the nocking point. Mark the location of the arrow rest and nocking point. Sight in the bow.